y2

Introduction :
The capacitors are constructed with a Metallized Polyester film dielectric, copper-ply lead, encapsulated in plastic case with epoxy resin sealed. They provide Interference Suppression of class Y. VDE 0565-1 approval file No. 12251-4670- 1001/A1K and meet the standards of UL 1414, CSA C22.2 NEMKO 132/85.
Applications :
Ideal for use in Line by-pass antenna coupling, across-the-line and spark killer circuits. available or EMI filter. and switching power supply applications.

Features :
Non-inductive construction Self-healing properties. Flame-retardant plastic case and epoxy resin. (compliance with UL 94v-0) High moisture-resistance. Good solderability. ( tinplated with 60Sn/40Pb ).	Application of Line-By-Pass

General specification :
Operating temperature range : - 40 ~ + 85C Rated voltage : 250VAC, 50~60Hz Capacitance range : 0.001uF ~ 0.047uF Capacitance tolerance : J ( 5% ), K ( 10% ), M ( 20% ) Dissipation factor : DF 1.0% when measured at 1KHz 25C Insulation resistance : IR >=15000 M measured after a charging voltage 100 15VDC for 1 minute. Dielectric strength test : Applied 1500 VAC for 1 minute. Humidity test : Will withstand the test of R.H. 95% at 40C for 21 days. After the test, the capacitance drift 5%, IR>=50% of specified value. Life test : At 85C applied the test with 440 VAC for 1008 hours. During this period, applied 0.1 sec of 1000 VAC 60Hz for each hour. The capacitor must meet the following limits. A ) Capacitance drift 10% of the initial value. B ) Insulation resistance >= 50% of specified value. Lead pull test : will withstand a steady pull of 4 kg applied axially for 10 seconds. Lead bend test : The test consists of attaching a load of 1 kg to the capacitor 90C from the direction of lead egress, then 180 in opposite direction and back to starting point. The lead will sustain two cycles without breaking.